18
1.
Fastening the plinth strip
Note:
Never cover the ventilation cracks in the base panelling.
Risk of damage to the appliance.
Nominal dimensions to be observed:
1. Where necessary, cut the base strip to the required
length.
2. Place base cover on the appliance (do not screw
on).
3. Take the protective film off from the adhesive pads
on the Velcro strip.
4. Put the base strip onto the base panelling and push
firmly.
5. Base strip can be screwed to the base cover from
behind. There are holes in the base cover for this
purpose.
2.
Aligning the base cover
1. Place base cover on the appliance (do not screw
on).
2. Measure the difference in depth
A
between the
base panelling and the base strip of the adjacent
lower cabinets.
3. Remove the base panelling again.
4. Adjust the brackets (a) to the dimensions
A
and
tighten.
5. Fasten the base panelling.
