Gaggenau RB 282, Руководство пользователя

Страница: 40 / 123

40
en
Home Connect
Verify signal strength
You should verify the signal strength if no connection
can be established.
1 Press the
·
button.
The refrigerator compartment temperature display
shows
Cn .
2 Press button -/+ refrigerator compartment until the
refrigerator compartment temperature display
shows
SI . In the freezer compartment temperature
display a value appears between 0 (no signal) and
3 (full signal).
The signal strength should be at least 2. If the
signal strength is too weak, the connection may be
interrupted.
– Place the router and refrigerator closer together.
– Ensure that the connection is not interfered with
by screening walls.
– Alternatively, install a repeater to make the
signal stronger.
Resetting Home Connect settings
If there is a problem when trying to establish a
connection or if you would like to register the appliance
in a different home network (WLAN), the Home Connect
settings can be reset:
1 Press the
·
button.
The refrigerator compartment temperature display
shows
Cn .
2 Press button -/+ refrigerator compartment until the
refrigerator compartment temperature display
shows
rE and the freezer compartment temperature
display shows OF .
3 Press button -/+ freezer compartment.
Freezer compartment temperature display shows an
animation for 15 seconds.
Then the freezer compartment temperature display
shows
OF .
The Home Connect settings have been reset.
Installing updates for the Home
Connect software
The refrigerator checks at regular intervals whether
updates are available for the Home Connect software.
If an update is available, the refrigerator compartment
temperature display shows
UP .
Pressing any button will reset the display to the set
temperature.
Installing the update:
1 Press the
·
button.
The refrigerator compartment temperature display
shows
Cn .
2 Press button -/+ refrigerator compartment until the
refrigerator compartment temperature display
shows
UP and the freezer compartment
temperature display shows OF .
3 Press button -/+ freezer compartment.
The freezer compartment temperature display
shows an animation.
The update will be installed.
During the installation, all buttons are locked.
– If the installation was successfully completed,
the freezer compartment temperature display
will show
On .
– If the installation was not successfully
completed, the freezer compartment
temperature display will show
Er .
Start the update again at a later time.
Inform the Customer Service if the installation
has still not been successfully completed after
several attempts.