10 - ENGLISH
www.gaggenau.com/us
HOT WATER CONNECTION
Openings for water lines must be
installed in the marked areas as shown
in Figures 8 and 9 to avoid
interference with the dishwasher
frame or other components.
• If using a solder joint instead of a com-
pression fitting,
be sure to make all
solder connections before connecting
the water line to the dishwasher
.
• Make sure there are no sharp bends or
kinks in the water line which might
restrict water flow.
• When connecting threaded pipe use pipe
thread compound or Teflon tape to seal
the connection.
• Before connecting the copper hot water
supply line to the dishwasher, it should
be flushed with hot water to clear any
foreign material.
• Apply Teflon tape or other pipe sealant
to 90° elbow fitting and connect
directly to water inlet valve (located at
the bottom front of the dishwasher)
• Turn on the water supply to check for
leaks after making connections.
Connecting the Hot Water
Supply Line
Figure 16
Figure 15
Shut off valve
(not included)
THESE INSTALLATION
INSTRUCTIONS ARE
INTENDED FOR USE BY
QUALIFIED INSTALLERS
DO NOT SOLDER WITHIN 6 INCHES
(152.4 MM) OF THE DISHWASHER’S
INLET VALVE.
TEMPERATURES REQUIRED FOR
SOLDERING WILL DAMAGE THE
VALVE!
CAUTION
* See Figure 15 and 16-water inlet
valve and 90° elbow
(located at the bottom front left-
hand side of the Dishwasher.)
Water
inlet
valve
