Gaggenau DF480161, Инструкция по эксплуатации

Страница: 30 / 48

en
Operating the appliance
30
Tone volume
The end of the programme is indicated by a buzzer. You
can also change this setting.
Button volume
When you are operating the dishwasher, a signal
sounds whenever a button is pressed. You can control
the volume of the signal. If you do not like the button
volume, you can switch it off.
Child-proof lock *
Child-proof lock
* depending on the features of your dishwasher
The dishwasher features an electronic child-proof lock.
The child-proof lock protects children from potential
hazards which the dishwasher poses.
You can switch the child-proof lock on or off. When the
child-proof lock is on, it is difficult to open the door.
Greeting
When you switch on the dishwasher, the brand logo
appears. You can switch off the brand logo.
Factory setting
You can reset all settings to the factory setting.
Switching the appliance on
1.
Turn on tap fully.
2.
Open the door.
3.
Switch on ON/OFF switch
(
.
The Eco 50° programme has been preset for
environmentally friendly operation whenever the
appliance starts. This programme remains selected if
no other programme button
0
is pressed.
4.
Press START button
)"
.
5.
Close the door.
Programme sequence starts.
Note:
For ecological reasons the Eco 50° programme is
preset whenever the appliance starts. This conserves
environmental resources and not least saves you money.
The Eco 50° programme is a particularly environmentally
friendly programme. According to EU regulation 1016/2010
it is the “Standard programme” which is the most efficient
standard cleaning cycle for cleaning normally soiled
utensils in terms of the combined energy and water
consumption for cleaning these types of utensils.
Time preselection
You can delay the start of the programme by up to 24
hours. Depending on the setting of the time display, the
end of programme is indicated with “Finish in” (for
example 3h 25m) or “Finish at” (for example 15:20
hours).
1.
Open the door.
2.
Switch on ON/OFF switch
(
.
3.
Selects programme
0
.
4.
Press time preselection button
`
.
5.
Keep pressing the setting buttons + -
X
until the
displayed time corresponds with your requirements.
6.
Press START button
)"
, timer programming is
activated.
7.
To delete the time preselection, press START button
)"
for approx. 3 seconds.
Time preselection was terminated.
8.
Close the door.