Gaggenau DF480101F, Инструкция по применению

Страница: 61 / 76

Troubleshooting
en
61
Fault Cause and troubleshooting
Water marks on
plastic parts. Due to laws of physics droplet formation on plastic
surfaces is unavoidable. After drying water marks are
visible.
▶
Select a more intensive programme.
→
"Programmes", Page 19
▶
Position tableware at an angle.
→
"Arrange tableware", Page 38
▶
Use rinse aid.
→
"Rinse aid", Page 34
▶
Set the water softening system higher.
→
"Setting the water softening system", Page 32
Wipeable or water-sol-
uble coatings are
present inside the ap-
pliance or on the
door. Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent → Page 35 .
▶
Clean the appliance mechanically.
White coating is deposited in the appliance interior.
1.
Set the water softening system correctly.
→
"Setting the water softening system", Page 32
In most cases you will need to increase the setting.
2.
Change your detergent if required.
Special salt dispenser is not screwed tight.
▶
Screw the special salt dispenser tight.
Stubborn white coat-
ings are present on
tableware, inside the
appliance or the door. Detergent substances are deposited there. These
coatings cannot generally be removed with chemicals.
▶
Change your detergent → Page 35 .
▶
Clean the appliance mechanically.
Hardness range is set incorrectly or the water hard-
ness is too high.
→
"Overview of water hardness settings", Page 31
▶
Set the Water softening system to the water hard-
ness or add special salt.
3in1/organic/eco detergent is not effective enough.
▶
Set the Water softening system to the water hard-
ness and use separate detergents (proprietary de-
tergent, special salt, rinse aid).
Too little detergent is being used.
▶
Increase the amount of detergent used or change
Detergent →
Page 35 .
Washing programme selected too weak.
▶
Select a more intensive washing programme.
→
"Programmes", Page 19