Gaggenau DF270101F, Инструкция по применению

Страница: 30 / 72

en
Water softening system
30
Water hardness
°E Hardness range mmol/l Setting value
9 - 10 Soft 1.2 - 1.4 9 - 10
11 - 12 Medium 1.5 - 1.8 11 - 12
13 - 15 Medium 1.9 - 2.1 13 - 15
16 - 20 Medium 2.2 - 2.9 16 - 20
21 - 26 Hard 3.0 - 3.7 21 - 26
27 - 38 Hard 3.8 - 5.4 27 - 38
39 - 62 Hard 5.5 - 8.9 39 - 62
Note:
Set the water hardness determ-
ined on your appliance.
→
"Setting the water softening sys-
tem", Page 30
With a water hardness of 0 - 8 °E
you can dispense with special salt for
dishwashers and switch off the water
softening system.
→
"Switching off the water softening
system", Page 31
11.2 Setting the water soften-
ing system
Set the water hardness on your appli-
ance.
1.
Determine the water hardness and
the appropriate setting value.
→
"Overview of water hardness set-
tings", Page 29
2.
Press ⁠.
3.
To open the basic settings, press
for approx. 3 seconds.
4.
Press repeatedly until the display
shows "Water hardness".
5.
Press or repeatedly until the
right water hardness has been set.
The value 16 - 20 is set at the fact-
ory.
6.
To save the settings, press for
approx. 3 seconds.
11.3 Special salt
You can use special salt to soften
water.
Adding special salt
If the special salt refill indicator lights
up, add special salt to the dispenser
for special salt just before the pro-
gramme starts. The consumption of
special salt depends on the water
hardness. The higher the water hard-
ness, the greater the consumption of
special salt.
ATTENTION!
Detergent may damage the water
softening system.
▶
Only fill the dispenser of the water
softening system with special dish-
washer salt.
Special salt for dishwashers can
damage the tub due to corrosion.
▶
To make sure that any special salt
that escapes is washed out of the
tub, add the special salt to the dis-
penser for special salt immediately
before the programme starts.
1.
Unscrew the lid of the dispenser
for special salt and remove.
2.
On initial start-up: Fill the dispenser
right up with water.