Gaggenau D 240, Руководство по эксплуатации

Страница: 14 / 23

14
Switching the dishwasher OFF
Several minutes after the programme has ended:
Open the door when the programme has ended.
Set main switch
1
to OFF.
Turn the water tap off.
(Does not apply when Aqua-Stop unit has been
fitted)
Remove dishes, etc. when they have cooled down.
At the end of the programme please open the door fully
and not partially when emptying the dishwasher. Any
escaping water vapour could damage sensitive
worktops.
Interrupting the programme
Open the door. Caution! There is a risk of water
squirting out from inside the appliance. Do not open
the door fully until the spray arm has stopped
rotating.
Set main switch
1
to OFF.
Indicator lights extinguish. The programme is
retained in the dish- washer memory.
If the hot water was switched ON or the appliance has
already heated up and then the appliance door opened,
leave the door ajar for several minutes and then close.
Otherwise, the appliance door may fly open due to
expansion.
In order to continue with the stored programme, set
the main switch to ON again and close the door.
Terminating the programme (Reset)
Simultaneously press programme buttons
A
and
C
for approx. 3 sec.
The numerical display indicates .
Close the door.
The programme sequence lasts approx. 1 min.
Switch off the main switch
1
.
Changing the programme
When the appliance is switched on, the programme
can be changed within minutes.
If the programme is changed subsequently, programme
sections (e.g. Cleaning) which have already started run
to the end. The new remaining time consists of the
remaining time of the previous programme section
and the remaining time of the newly selected
programme.
Intensive drying
In the final rinse the appliance operates at a higher
temperature and therefore an improved drying result is
obtained. (Caution if utensils are fragile!)
Hold down programme button
A
and press main
switch until
1
the digital display illuminates.
Release both buttons.
The LED for button
A
flashes and the digital display
9
displays the factory setting (off) or (on).
To change the setting, press programme button
A
.
Switch off the main switch
1
.
Additional functions
*
on some models additional functions
2
can be set
with the buttons.
Soaking *
The soaking cycle runs before the main programme
and must be selected before the programme starts. In
this additional programme cooking utensils, e.g. pans,
bowls, etc., can be soaked and prerinsed in the
bottom basket.
It is recommended to put approx. 5 g of detergent on
the door.
Reduce/save time*
The rinsing times and the drying phase are reduced.
The reduced time lowers the rinsing and drying
performance.
Top basket washing only *
If there are only a few utensils (e.g. glasses, cups,
plates), use the top basket. The bottom basket must be
empty!
Use slightly less detergent than is recommended for a
complete load.
Bottom basket washing only *
If there are only a few utensils (e.g. plates, pans,
bowls), use the bottom basket. The top basket must be
empty!
Use slightly less detergent than is recommended for a
complete load.