Gaggenau CX 492, Инструкция по применению

Страница: 19 / 36

Wireless cooking sensor
en
19
2.
Now stop pressing the centre of the wireless cook-
ing sensor.
a
As soon as the LED goes out, this means that the
wireless cooking sensor has been reset.
3.
Repeat the connection process from point 2.
Setting the boiling point
The point at which water starts to boil depends on the
height of your home above sea level. If the water is
boiling too vigorously or not vigorously enough, you
can adjust the boiling point. Proceed as follows:
Select the "Set boiling point" setting in the basic set-
tings. →
Page 23
The default basic setting is 200–400 m. If your home is
located at this height above sea level, do not set the
boiling point. Select the setting that matches your
home's height above sea level.
Note:
Temperature 4/100 ºC is sufficient to boil effi-
ciently. For a more intensive boil, select a lower level.
Tip:
If you want to set the temperature more precisely,
you can increase or decrease this by 1 °C to 5 °C. To
do this, touch the selected temperature and then select
​⁠. Then select the required temperature and press ​⁠
to confirm. To cancel and exit the menu, touch the
​⁠ symbol.
16 Wireless cooking sensor
To use Cooking sensor, you must purchase a wireless
cooking sensor.
You can purchase the wireless cooking sensor from
customer service, in our online shop or in a specialist
shop www.gaggenau.com.
16.1 Scope of delivery
After unpacking all of the parts, check for any transport
damage and for completeness of delivery.
¡
​⁠ Wireless cooking sensor
¡
​⁠ Silicone patch
¡
​⁠ Template
16.2 Attaching the silicone patch
The silicone patch secures the cooking sensor to the
cookware. For fitting on the cookware:
1.
The adhesive area on the cookware must be free
from grease. Clean and dry the container thor-
oughly, and rub the adhesive area using alcohol, for
example.
2.
Remove the protective film from the silicone patch.
Adhere the silicone patch to the outside of the cook-
ware in the correct place using the enclosed tem-
plate as a guide.
3.
Press down all over the surface of the silicone
patch, including in the centre.
4.
Leave the adhesive to dry for one hour. Do not use
or rinse out the cookware during this time.
Note:
If the silicone patch comes loose, use a new
one. If required, you can purchase a set with five silic-
one patches from specialist retailers, from our cus-
tomer service or on our official website www.gag-
genau.com by quoting the article number 17007119.
All adhesives break down over time when they are
stored. To prevent this from happening, place the silic-
one bases on their containers as soon as they are
cleaned.
16.3 Attaching the wireless cooking sensor
1.
Ensure that the silicone patch is completely dry be-
fore attaching the cooking sensor.
2.
Attach the cooking onto the silicone patch so that it
fits perfectly.