en
Cooking sensor function
26
Note:
The 100 °C temperature setting provides effi-
cient cooking even if the water does not bubble very
strongly during the heating process. If you are not sat-
isfied with the cooking result, however, you can change
the boiling point setting.
Overview of the boiling point settings
The setting values for the boiling point depend on the
height of your home.
Height
Setting value
0-100ºm
100-200ºm
200-400ºm
1
400-600ºm
600-800ºm
800-1000ºm
1000-1200ºm
1200-1400ºm
Above 1400ºm
1
Basic setting
19.7 Connecting the wireless cooking
sensor to the control panel
1.
Select the basic setting
.
a
lights up white.
2.
Press .
a
A signal tone sounds.
a
lights up orange.
a
The indicators light up white and the cooking sensor
displays on the cooking zones flash.
3.
Press on the wireless cooking sensor within the
next 30 seconds.
Detection successful:
The wireless temperature
sensor is detected within a few seconds. Three
short beeps sound and the symbol changes from
orange to white. The cooking sensor displays on the
cooking zones go out.
Detection failed:
Five beeps sound. changes
from orange to white. The cooking sensor displays
on the cooking zones go out.
Note:
If there is a fault with the wireless cooking sensor,
the connection may not be established correctly for
the following reasons:
¡
Bluetooth communication error
¡
You have not pressed the symbol on the cooking
sensor within 30 seconds of selecting the cook-
ing zone.
¡
The battery in the cooking sensor is flat.
4.
If the connection cannot be established correctly
due to a fault, reset the cooking sensor →
and repeat the connection procedure.
5.
If the connection cannot be established correctly
due to a transmission error, repeat the connection
procedure.
6.
If a connection cannot be established, inform cus-
tomer service.
a
The cooking sensor function is available as soon as
the cooking sensor is connected to the control
panel.
19.8 Resetting the wireless cooking sensor
1.
Press and hold for 8-10 seconds.
While you are doing this, the cooking sensor's LED
indicator lights up three times.
a
The reset starts when the LED lights up for the third
time.
2.
Do not press again.
a
When the LED goes out, this means that the wire-
less cooking sensor has been reset.
3.
Repeat the connection procedure from step 2.
→
19.9 Activating the cooking sensor function
Requirements
¡
The hob is switched on.
¡
The connection is established between the wireless
cooking sensor and the control panel.
→
"Connecting the wireless cooking sensor to the
1.
Attach the cooking sensor to the cookware.
2.
Place the cookware with sufficient liquid in the
middle of the required cooking zone and always put
a lid on.
3.
Use the twist knob to select the required cooking
zone.
a
appears in the display for the cooking zone.
4.
Press in the control panel.
a
A signal tone sounds.
a
lights up in the display for the cooking zone.
5.
Press on the wireless cooking sensor.
a
Once the cooking sensor has been detected, the
default temperature of 95 °C lights up in the dis-
play.
