Gaggenau CMP250111, Инструкция по эксплуатации

Страница: 26 / 32

26
en
Service programmes
Service programmes
Service programmes
(Also see the quick reference guide)
Every so often – the exact frequency depends on usage
and water hardness – one of the following messages
will appear in the display in place of the coffee
selection:
▯
Please change water filter
▯
Please clean
▯
Please descale
▯
Please descale and clean
The
)
warning symbol then lights up.
The water filter should be changed immediately at this
point and the appliance cleaned or descaled using the
appropriate programme. Otherwise the appliance may
be damaged.
The service programmes can also be started at any time
without any prompt from the display. Set the function
selector to
S and select and run the desired programme.
Notes
– Caution! Do not drink or come into contact with
cleaning or descaling materials. Keep cleaning
materials and descaling tablets out of the reach of
children. They may be toxic.
– Important: If the appliance is not descaled in good
time, the message "Appliance locked Descaling
required urgently" will appear. Immediately perform
the descaling process in accordance with the
instructions. If the appliance is locked, it can only
be operated again once descaling has been carried
out.
– Caution! With each of the service programmes, use
descaling and cleaning agents as described in the
instructions and observe the (relevant) safety
information.
– Do not drink the liquids.
– Never use vinegar, vinegar-based products, citric
acid or citric acid-based products for descaling.
– When cleaning and descaling, only use the tablets
intended for such purpose. They have been
specially developed for this appliance, and new
stocks can be ordered through the after-sales
service.
~
"Accessories" on page 9
– Never insert descaling tablets or other products
into the grounds compartment.
– Never interrupt the service programme.
– Prior to starting a service programme, remove,
clean and reinsert the brewing unit. Rinse the milk
system.
– At the end of a service programme, wipe down the
appliance using a soft, damp cloth to immediately
remove any descaler residue. This residue may
cause corrosion.
– New sponge cloths may contain salts. Salts can
cause rust film on stainless steel, so cloths must
always be washed out thoroughly before use.
– If a service programme is interrupted, e.g. by a
power failure, proceed as follows:
1 Rinse out the water tank.
2 Pour in fresh, still water up to the " max " mark and
confirm.
The programme starts and rinses the appliance.
Duration approx. 2 minutes.
3 Empty, clean and reinsert the drip tray.
– Caution! Do not drink the descale solution.
Cleaning
Duration: approx. 5 minutes
Prior to starting the service programme, clean the
brewing unit.
~
"Cleaning the brewing unit"
on page 25
1 Rotate the function selector to S .
2 Select "Cleaning programme" using the rotary
selector.
3 Touch the
™
symbol.
The cleaning programme starts. The information in
the display guides you through the programme.
4 Empty and reinsert the drip tray and the coffee
residue container.
5 Place a cleaning tablet in the ground coffee drawer
and close the drawer again.
6 Close the door.
7 Place a container with a capacity of 0.5 l under the
beverage dispenser.
8 Touch the
I
symbol.
The programme will run for approx. 5 minutes.
9 Empty and reinsert the drip tray.
10 Touch the
™
symbol.
The cleaning programme has now ended.