Gaggenau BSP 270, Инструкция по эксплуатации

Страница: 38 / 56

38
en
What to do in the event of a fault
3
What to do in the event of a fault
What to do in the event of a fault
Malfunctions often have simple explanations. Please
read the following notes before calling the after-sales
service.
m
Warning – Risk of electric shock!
Incorrect repairs are dangerous. Repairs may only be
carried out and damaged power cables replaced by one
of our trained after-sales technicians. If the appliance is
defective, unplug the appliance from the mains or switch
off the circuit breaker in the fuse box. Contact the after-
sales service.
m
Warning – Risk of injury!
The light emitted by LED lights is very dazzling, and can
damage the eyes (risk group 1). Do not look directly into
the switched on LED lights for longer than 100 seconds.
LED lights
Defective LED lights must only be replaced by the
manufacturer, their customer service department or a
licensed technician (electrician).
Disruption Possible cause Solution
Appliance not working, no display Plug not inserted Connect the appliance to the electricity mains
Power failure Check whether other kitchen appliances are
working
Fuse defective Check in the fuse box whether the fuse for the
appliance is in working order
Operating error Switch off the fuse for the appliance in the
fuse box and switch it on again after about 60
seconds
The appliance does not work, the dis-
play shows "Device locked. Descaling
required." Build-up of limescale in the appliance Start the descaling programme
~
"Descaling programme" on page 36
Despite descaling, "Please descale"
appears on the display Build-up of limescale in the appliance,
wrong descaler used Use the specified descaling tablets, start the
descaling programme
~
"Descaling
programme" on page 36
Appliance cannot be started Appliance door is not quite closed Close appliance door
The appliance is not working and the
display does not respond.
0
appears
on the display
Childproof lock activated Deactivating the childproof lock
~
"Childproof lock" on page 21
Appliance switches off on its own Safety shut-off: the appliance has not
been operated for longer than 12 hours Confirm the message with
™
, switch off the
appliance and set it again.
Appliance does not heat up,
°
appears
in the display
Appliance is in demo mode Deactivate the demo mode in the basic set-
tings
The appliance cannot be started, a mes-
sage is shown on the display No water available in the appliance Check the water connection
The core temperature probe is inserted
but the
+
symbol is not displayed
Moisture on the socket in the cooking
compartment Move the core temperature probe shaft in and
out of the socket in the cooking compartment
several times
No steam visible in the oven Steam above 100°C is invisible This is normal
The "steam removal"
3
symbol does not
appear on the display
The steam removal function is only avail-
able if the oven temperature is below
130°C This is normal
Powerful steam outlet at the top of the
door The operating mode has been changed This is normal
A lot of steam escapes at the side of the
door Door seal soiled or loose Clean the door seal and insert it in the groove
Humming noise when switching on The drain pump starts to operate This is normal
Appliance has been switched off for sev-
eral days This is normal: automatic rinsing when being
switched on again
A whistling noise occurs during heating Noises may occur during steam genera-
tion
This is normal
There is a "pop" noise during cooking Cold/warm effect with frozen food,
caused by the steam This is normal