Gaggenau AC 200, Инструкция по эксплуатации

Страница: 17 / 44

17
Cleaning and maintenance
m
Risk of burns!
The appliance will become hot during operation,
especially near the bulbs. Allow the appliance to cool
down before cleaning.
m
Risk of electric shock!
Penetrating moisture may result in an electric shock.
Clean the appliance using a damp cloth only. Before
cleaning, pull out the mains plug or switch off the circuit
breaker in the fuse box.
m
Risk of electric shock!
Do not use any high-pressure cleaners or steam
cleaners, which can result in an electric shock.
m
Risk of injury!
Components inside the appliance may have sharp
edges. Wear protective gloves.
Cleaning agents
To ensure that the different surfaces are not damaged
by using the wrong cleaning agent, observe the
information in the table. Do not use any of the following:
▯
Harsh or abrasive cleaning agents,
▯
Cleaning agents with a high alcohol content,
▯
Hard scouring pads or cleaning sponges,
▯
High-pressure cleaners or steam cleaners.
Wash new sponge cloths thoroughly before use.
Follow all instructions and warnings included with the
cleaning agents.
Removing metal grease filter
1 Open the filter cover.
Note: Grasp the front corners of the filter cover and
pull it down in a single, swift motion.
2 Open the lock and fold down the metal grease filter.
Note: To avoid causing damage, do not bend the
metal grease filter.
3 Take the metal grease filter out of the holder.
Note: Fat may accumulate in the bottom of the
metal grease filter. Hold the metal grease filter level
to prevent fat from dripping out.
4 Clean the appliance from the inside.
5 Clean the metal grease filter and let it dry before re-
fitting.
Area Cleaning agent
Stainless steel Hot soapy water:
Clean with a dish cloth and then dry
with a soft cloth.
Clean stainless steel surfaces in the
grind direction only.
Special stainless steel cleaning prod-
ucts are available from our after-sales
service or from specialist retailers.
Apply a very thin layer of the cleaning
product with a soft cloth.
Painted surfaces Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Do not use any stainless steel cleaners.
Aluminium and plas-
tic Glass cleaner:
Clean with a soft cloth.
Glass Glass cleaner:
Clean with a soft cloth. Do not use a
glass scraper.
Controls Hot soapy water:
Clean using a damp dish cloth and dry
with a soft cloth/towel.
Risk of electric shock caused by pene-
trating moisture.
Risk of damage to the electronics from
penetrating moisture. Never clean
operating controls with a wet cloth.
Do not use any stainless steel cleaners.
Area Cleaning agent