7
REV 1/24
GB745/206
-
500SH INSTALLATION TOOL
S/N 1004 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
PRINCIPLE OF OPERATIONS
When the actuator is depressed, the throttle valve is shifted, directing the pressurized air inside the tool to the bottom of the air
piston assembly, moving it in an upward direction. The air above the air piston assembly is then directed out the exhaust, on
the bottom of the tool. Simultaneously, the piston rod assembly connected to the air piston assembly is also moving up, forci ng
hydraulic oil up and into the front of the cylinder machined, causing the piston assembly to move to the rear of the cylinder
machined. The oil from the rear of the cylinder machined is directed to the bottom of the piston rod assembly, inside the handle
assembly. The internal components of the attached nose assembly are also moving with the piston assembly to start the fastener
installation. When the fastener installation is completed the actuator is released allowing spring pressure to move the throt tle
valve to shift, directing the air pressure to the top side of the air piston assembly and reversing the sequence.
Pressurized Oil
Unpressurized Oil
Pressurized Air
Unpressurized Air
Images may not reflect actual tool
Air exhaust
Air Piston
moves down
Piston Rod Assembly
moves down
Piston Travel
PULL Cycle
RETURN Cycle
Piston Travel
Air Piston
moves up
Piston Rod Assembly
moves up
Air exhaust
Air exhaust
