Gage Bilt GB714, Оригинальное руководство пользователя

Страница: 13 / 20

13 REV. 3/21
GB714 INSTALLATION TOOL
.
S/N: 1001 AND ABOVE
PLEASE CONTACT GAGE BILT FOR ALL OTHER SERIAL NUMBERS.
Part No. Description
704149 Piston Rod Wrench Assy
704151 Power Cylinder Tool Assy
704150 Packing Plug Wrench Assy
704152 Seal Guide
704153 Air Bleeder Assy
744251 Valve Spring Installation Tool
744152 Valve Sleeve Removal Tool
S1178 Valve Extractor
GB740TK Service Tool Kit Includes:
TOOL DISPOSAL
1. When tool life is met, drain hydraulic oil from tool and dispose of the hydraulic oil in accordance with SDS datasheet.
2. Disassemble tool and remove all rubber o ’ rings, seals, wipers and hydraulic hoses. All tool materials are recyclable except rubber
o ’ rings, seals, wipers and hydraulic hoses. Dispose of rubber materials in accordance with all environmental regulations applicable
in your area.
OVERHAUL
WARNING :
Only qualified and trained personnel should perform overhaul.
WARNING :
Personnel must read and understand all warnings and cautions.
WARNING :
Tool must be maintained in a safe working condition at all times and examined on a daily basis for damage or
wear. Any repair should be done by qualified personnel trained on Gage Bilt procedures.
WARNING :
Disconnect tool from its power source before performing overhaul. Severe personal injury may occur if power
source is not disconnected.
WARNING :
Excessive contact with hydraulic oil and lubricants should be avoided (See SDS documents for all applicable
materials
).
WARNING :
When operating, repairing or overhauling tool, wear approved eye protection. Do not look in front of tool or
rear of tool when installing fastener.
WARNING:
Ensure air hose is securely connected to avoid possible hose whipping (Air Actuated Tools only).
WARNING:
Depress actuator assy - air (704130) and disconnect from air, with the piston in the rear position, before overhaul.
Severe personal injury may occur if air hose is not disconnected. USE CAUTION when forcing piston rod assy
downward with head cylinder removed. Hydraulic oil will eject forcibly from handle assy.
Perform overhaul in a clean, well lit area using care not to scratch or nick any smooth surface that comes in contact with an o'ring. Use
of Lubriplate® (Gage Bilt part no. 402723) or other lubricant is recommended during reassembly to prevent tearing or distorting of o'rings.
The disassembly and re - assembly procedure can be accomplished by utilizing the following instructions and parts lists on pgs. 13 - 16. Use
extreme care during disassembly and re - assembly not to mar or nick any smooth surface that comes in contact with seals. Before installing
seals, always apply a good lubricant, such as Lubriplate®, to the surfaces. It is recommended that service tool kit (GB740TK) be used to facilitate
overhaul. A complete overhaul can be achieved by the use of Service Kit (714001) which contains a complete set of o'rings, back - up
rings, screws, washers and gasket.
Clean parts in mineral spirits or other o'ring compatible solvent being sure to clean o'ring grooves. Inspect components for scoring,
excessive wear or damage.
Note:
•
Dispose of hydraulic oil in accordance with manufacture safety datasheet.
•
All tool materials are recyclable except rubber o ’ rings, seals and wipers.