13
Rev. 5/22
GB204/GB204(A) INSTALLATION TOOL
Note: Gage Bilt does not recommend using a pneumatic lubricator or adding pneumatic oil to the air inlet on our tools or powerunits
Stroke limiters are designed for the protection of the operator and equipment. Failure to operate tool with a stroke limiter as required
will result in damage to the nose assembly or tool and may result in personal injury. If you are unsure your nose assembly requires a
stroke limiter, contact Gage Bilt.
For use when a shorter stroke tool is required.
(Sold separately).
1.
To install or remove stroke limiter (206112), see overhaul instructions (#1 thru #7) on pg.12
2. To reduce stroke to
.375” (9.5
mm), remove relief valve (206109) from the piston assembly (204111). Install stroke limiter (206112)
and relief valve (206110),
flats to rear of the tool
, to piston assembly (204111). Note positions and locations shown below.
Relief Valve (206110)
STROKE LIMITER
-
INSTALLATION & REMOVAL
Stroke Limiter (206112)
Piston Assembly (208111)
Stroke Limiter (206112)
Position relief valve
flats to
REAR
of tool.
Images may not reflect actual tool.
Do
NOT
position relief valve
flats to front of tool.
Front of tool.
Rear of tool.
