81
4. Operation of systems and equipment
INT: intermittent wiping*
-
If the wiper combination switch is turned
to the
③
INT position, the front wiper will
start wiping intermittently.
- For the models equipped with the
automatic wiping function, this function
can be activated via “Settings → Body
Accessories → Other Accessories →
Automatic Wiper” in the AV system.
- Adjust the intermittent wiping speed by
turning the knob
⑦
up/down.
LO: low speed wiping
-
If the wiper combination switch is turned
to the
④
LO position, the front wiper will
wipe at a slow speed.
HI: Quick wiping
-
If the wiper combination switch is turned
to the
⑤
HI position, the front wiper will
wipe at a high speed.
Front windshield washer system on
-
If the wiper combination switch is turned
toward the rear of the vehicle to the
⑥
position, the front washer will start
spraying water and then the front wiper
will start wiping.
- If the wiper combination switch is released
to return to its original position, the front
windshield washer system will be stopped
and the front wiper will wipe once after
about 6s.
-
After the front wiper motor stops wiping for
about 6 s, it will wipe again to remove the
remaining water stains on the windshield.
Front wiper maintenance
-
Method 1: Within 10 s after switching
the ENGINE START/STOP button to the
“OFF” position, if you turn the control lever
of the wiper combination switch to
①
MIST position and then quickly release it
to return it to the original position, the front
wiper will move to the highest position and
then stop, so that the wiper maintenance
mode is activated.
- Method 2: When the ENGINE START/
STOP button is in the “ON” position,
click “Settings → Body Accessories →
Other Accessories → Wiper Maintenance
Mode” in the AV system to enter the wiper
maintenance mode.
4.3.4 Windshield
Windshield
The front windshield is made of green glass.