ASSEMBLY INSTRUCTIONS FOR CONCEALED SHOWER OR BATH SHOWER DIVERTER MIXER
- Make a hole i the all A i o de to positio the
mixer.
2- Flush through the water pipes to remove all impurities.
- Pla e the all i e ithout e o i g the E
A= Wall
p ote tio . I po ta t: he ou i se t the i e ’s
B= Entering pipes
body check the maximum and minimum measure
C= Second exit pipe
indicated on the technical design for the installation of
D= Main exit pipe
the mixer.
E= Protections
- Co e t the hot ate e te i g pipes B o the left, a d
F= Plate
the old ate e te i g pipes B o the ight.
G= Mixer lever
- Co e t the ai e it pipe D ajo ate flo apa it
H= Diverter knob
elo , a d the se o d e it pipe C i o ate flo
capacity) above.
6- Verify the watertight of the connections (by positioning
te po a the G le e .
7-Verify the correct functioning of the installation: opening
the le e , the ate has to pass f o the ai e it D
hile p essi g the utto H the ate has to pass f o
the se o d e it C .
-Re o e the G le e a d o plete the alli g a d the
covering.
- Re o e the p ote tio E a d u s e the k o of the
di e te H .
-Pla e the plate F a d, if e essa , sili o e it o the
wall. The eventual fixing silicone has to be applied on
the back side of the plate and only along the upper and
lateral edges.
DO NOT siliconate the lower edge of the plate.
-Pla e the G le e fi i g it ith the apposite s e ,
insert the plate and screw the knob.
NOTE
: In case of low water pressure, the diverter can even work
manually by pushing the button and turning it a quarter of turn.
