17
EN
4.- REMOTE OPERATION USING THE WIFI G-CONTROL HUB
It is possible to control the full operation of the unit remotely with Gabarron-Elnur app or app-web. The unit must be
connected to a Wifi G-Control Hub connected to the internet to use this feature.
4.1
To associate the unit to the G-Control Hub, the
discovery mode of the hub must be activated. Press the
associate button at the back of the Gateway for 3 seconds. An
orange blinking light every second indicates association mode.
4.2
With the hub in discovery mode, press the
Ok/Mode
button on the heater for 3 seconds until the Link symbol is
shown.
You can now control and adjust the programming and temperatures on the heater via the Gabarron-Elnur app.
4.3
To disassociate the unit, a reset of the unit must be realized. See “
5. UNIT RESET
”.
When the heater is reset, it will
remove the programming and revert back to the default settings and also disassociate from the RF network and G-Control Hub.
5.- UNIT RESET
The heater reset removes the programming and disassociates the device from the RF network if the unit was associated with a
G-Control Hub. Default values are established. To reset the unit, hold the
OK/Mode
and
Config/Prog
buttons simultaneously
for 10 seconds, the next figure will show the following to indicate the heater has been reset.
To confirm the reset of the unit, press
OK/Mode
button, to cancel it any other button can be pressed.
6.- DEFAULT VALUES
Operation mode
OFF
Comfort temperature
19ºC
Economic temperature
17ºC
Frost protection temperature
5ºC
Ambient sensor Offset
0ºC
RF associated
No
Temperature Unit
ºC
Open Window detection
Disabled
Control mode
PID
Default Programming in AUTO Mode
Economic 24h*7