©2010 G3 Genuine Guide Gear Inc.
G3-ATB-E004 Rev -
©2010 G3 Genuine Guide Gear Inc.
G3-ATB-E004 Rev -
1.2.
Installation of shim
•
Note the positions of the
binding toe on the ski
(+7.5mm,0,-7.5mm)
•
Remove the Onyx
binding toe from the ski
•
Using the T10 Torx key,
remove the screw shown
from the underside of the
binding
•
Using the T10 Torx key,
remove the long screw
shown and remove the
plastic Step-In Platform
•
Re-install the Onyx
binding toe onto the base
plate. Locate the toe in
the original position and
torque the toe
positioning screws to
5.6 N∙m (50 in∙lbf)
•
Place the drilling
template against the rear
edge of the toe base
plate. Mark the drilling
location with a pen or
centre-punch. Drill in the
marked location with a
Ø
3.5mm x 9mm or
Ø
4.1mm x 9mm drill.
(
Ø
4.1mm for skis with
metal topsheet)
•
Remove chips or dust
from the hole. The hole
should be glued with
waterproof glue and/or
tapped if recommended
by the ski manufacturer.
•
Position the T-Stud over
the hole and insert the
screw. Torque to
4 N∙m
(35 in∙lbf)
with a #3
Pozidrive driver.
•
Slide the shim over the T-
stud and align to the
Onyx binding toe. Insert
the long screw removed
earlier through the
binding toe and shim.
Torque to
1.7 N∙m (15
in∙lbf)
Warning: Using bellowed boots with the Onyx binding will affect the binding safety release
