G21 Lexi, Инструкция по эксплуатации

Страница: 4 / 31

Spare parts adjustment
1. Handlebar adjustment
• The handlebar stem must not be placed under the insertion mark
(Fig. A).
• Stand directly in front of the handlebar, grip the front wheel between
your legs and adjust the handlebars so that they are perpendicular to
the front wheel (Fig. B).
• Firmly attach handlebar to the stem with binder bolts.
2. Saddle adjustment
• The saddle should not be placed under the insertion mark (Fig. C).
• Insert the seat post into the bracket. Adjust the height with quick-
release axle and secure against movement.
Battery charging
• Connect the charger to the electric bicycle and into the AC 220 V/ 50 Hz socket.
• Charging time is 4-6 hours. Charging time must not exceed 18 hours.
• After charging disconnect the charger from the electrical outlet and from the electric bike.
Notice
• Use only charger that is supplied with the electric bicycle. Unoriginal charger could cause
overcharging of the battery. Do not use the battery charger specified for this electric bicycle for
charging other batteries.
• When the electric bicycle is not in use it is necessary to maintain a sufficient charge in the
battery to prevent breakdown of the electrolyte, which may lower performance. The battery should
be brought to a full charge once a month.
• Do not permit short-circuiting of the battery poles. This may damage the battery or cause a fire.
• Ensure that all battery connections are securely fastened to avoid potential fire.
• Do not expose the battery to fire or sources of high temperatures. Do not dispose the battery in
a fire and do not expose it to direct sunlight.
• If the battery casing is damaged, immediately replace the battery.
• The electrolyte is an acid solution. Try to avoid spilling this solution on your clothes, skin or
eyes. If this happens, immediately wash the affected area with clean water and find the medical
assistance.
Riding
You should be familiar with all the spare parts of this bike before riding. Operate your electric
bicycle according to the following instructions.
Starting up: Insert the key into the switch and turn to the ON position. The low level of assistant
(LOW) is automatically started after starting. For starting, we recommend that you keep the low
level set and you can set medium or high pedal assist level by pressing MODE button during the
ride.
Your bike is equipped with a rear break. If you press it, it automatically disconnects the power
supply to the motor and the wheel slows down. Then the bike stops completely.
Stop: After riding, turn the key to the “OFF” position.