* Information in this document can be modified without notice.
Gripset Handle Installation Instructions
Door Multi-point Locking System
Ø15.0
24.0
139.7
88.0
248.0
30.0
45.0
108.3
25.0
25.0
ALIGN WITH HEIGHT
MARK
ON T
HE GEAR F
ACEPLA
TE
EDGE OF DOOR SLAB
915mm (36'') T
O
BOTT
O
M OF DOOR
BOTTOM OF DOOR
Ø15.0
139.2
247.5
Ø15.0
HANDLE SET INSTALLATION
CUT OUT
1. EXTERIOR
Step 3:
For Salem handle only
, place nylon
washer on the handle shaft .
Step 4:
Loosen the set screw on the
handle with the supplied Allen key .
Handle should point towards the hinge side,
hold back-end of spindle while pushing
handle over spindle. Tighten the set screw
with the Allen key.
Step 5:
Position the interior handle
assembly on the spindle . Place
the knob onto the tail piece .
Step 6:
Fasten the assembly with 2 installa-
tion screws , but do not tighten. Check
operation of lock with thumb latch ,
be sure lock latches operate smoothly
and deadbolt will fully throw 1'' (25mm)
with 90° of turn. Fully tighten the 2
installation screws and re-test.
Step 7:
Fasten bottom screw through
washer . Snap the screw cover
over washer.
2. INTERIOR
for K-C2060/K-C2070
(RECOMMENED)
60mm BACKSET
* RIGHT HAND SHOWN *
Step 1:
For 1 3/4” (45mm) doors only
,
cut the cylinder tail at the mark.
Step 2:
IN UNLOCKED POSITION
Position the exterior handle
assembly in front of the cutouts,
make sure gasket is well seated.
Push the cylinder tail through
the cylinder slot, and at the same
time the spindle through the
spindle hole of the door gear.
1A
1A
1B
1
7
3
3
3A
4B
2
1B
1A
4A
1C
6B
6A
6C
2A
2B
1A
1
1B
2
7
4A
4A
6C
6B
6A
3
3A
4B
2A
2B
1C
