G-Tek Corporation Private Limited
33
7.3.8
Room Temperature
7.3.8.1
Offset
A small correction may be required when actual sensor is connected to the device. To set offset for
temperature reading, a mathematical value is directly added to the reading coming on led display with
the reference value which we consider as an accurate value coming on other display device or machine.
7.3.8.2
Multiplier
Sometime a major correction, may be required for temperature when actual sensor is connected to
the device. A mathematical value expects zero is directly multiplied to the reading coming on led
display to get the specific output on same led display and to store it during batch running.
To set Offset/ Multiplier for temperature follow the procedure shown in figure-35 by pressing the
appropriate buttons given on the front panel of the LmNet.
7.3.8.3
Alarm Set Point High
In this parameter we must set the value to alert us whenever device reading goes higher than the set
value, and that value should be set from -200 to 1000 °C
To set the Alarm Set point High for a channel then follow the procedure shown in figure- 35 by pressing
the appropriate buttons given in the front panel of the LmNet.
7.3.8.4
Alarm Set Point Low
In this parameter we must set the value to alert us whenever device reading goes lower than the set
value, and that value should be set from -200 to 1000 °C
To set the Alarm Set point low for a channel then follow the procedure shown in figure- 35 by pressing
the appropriate buttons given in the front panel of the LmNet.
Figure 35 Room Temperature
CJC
oFFSEt
mULtiPLy
1 128.55
0.0
1.000
Save
Save
Содержание LmNet - PRO 614-00
Страница 1: ......
Страница 10: ...G Tek Corporation Private Limited 9 Figure 6 LmNet connection with Adaptor and LAN Cable...