4
ON/OFF MODE
– Switching mode switch:
SWITCH position- classic mode by using of the switch
located in front of the pedal,
TOUCH position – Pressure activated mode by placing
the foot on the wah-wah.
Power supply
It is recommended to supply the wah-wah with a 9 V DC regulated
adapter (10 mA consumption). Before plugging the adapter please check the
pin polarisation.
ATTENTION: Damages caused by improper power supply causes the
loss of the warranty
.
Wah-wah can be also powered with a 9V
battery. To exchange the battery you should unbolt
the screw holding the cover, remove the cover and
plug the battery. It is recommended to use high
capacity alkaline batteries.
To power on the wah-wah in case of supplying from the adapter it is
needed to plug the MONO JACK pin to IN connector (BATTERY switch can
stay in any position). In case of supplying from the battery it is needed to plug
the MONO JACK pin to IN connector and to set the battery switch in ON
position. It enables easy battery supplying switching off (without necessity of
plugging off the Jack from IN connector).
