G Fox (Pty) Ltd
Pencil Park, Croxley Close
Heriotdale Ext 15,
Germiston
PO Box 751243
Gardenview, 2047
Phone: (011) 417 9300
Sales Fax: (011) 417 9400
Debtors Fax (011) 622 6307
Management Fax: (011) 417 9500
Email: [email protected]
Website:
www.gfox.co.za
Cape Town
(021)514 1400
Vredenburg
(022)713 1538
Durban
(031)274 0200
Richards Bay
(035) 789 5735
Middleburg
(013)246 2402
Midvaal
0861 000 751
Polokwane
Port Elizabeth
Swaziland
Zambia
(015)297 6314
(041)453 2178
+2682(518)6396 +260211847911
02118479112
Trading Agent of Bidvest Commercial Products (Pty) Ltd
Directors: H. Greenstein (Chairman), W. Pollak (Managing Director), S. Chuturgoon, L. Jacobs, G. McMahon, C. Turnbull
Use only in accordance with the provided instructions, labels and limitations relating to this product.
This product must be replaced subsequent to:
•
a single work shift
•
dust penetration occurring
•
mask becoming damaged
Report immediately to the Health and Safety representative should any of the following occur:
•
Breathing becomes difficult
•
Dizziness or other signs of distress
Do not use the product in the following conditions:
•
Atmospheres containing explosives, radioactive substances, fumes, toxic gases, enzymes or
vapours
•
Atmospheres where there may be a deficiency of oxygen
•
Atmospheres where the particulate concentration exceeds 10 x the PEL Permissable
Exposure Level
FITTING INSTRUCTIONS
1. Hold the respirator in your hand with the hollow side facing upwards and the nose clip at your fingertips,
allowing the ear loops to hang freely over the edges of your hand.
2. Place the bottom edge of the mask below your chin and press the mask firmly against your face,
covering your mouth and nose, with the nose clip at the bridge of your nose.
3. Pull the ear loops over your ears, one at a time with your free hand while holding the respirator firmly in
place with the other.
4. Pinch the nose clip to bend around the nose creating a snug seal.
FIT TEST:
Cup both hands over the respirator and exhale suddenly and forcefully. If air escapes around the
nose, adjust and tighten the nose clip to the shape of the nose.. If air escapes around the edges of the
respirator, reposition the ear loops for a better fit. Retest the seal and repeat the procedure until the
respirator is sealed properly.
DO NOT enter the hazardous environment if a proper fit cannot be achieved.
Disclaimer: The information provided in this data sheet is correct to the best of our knowledge. Information given is designed
only as a guidance for safe handling use.
