22
TC 40
Original Instructions - rev.1 - 2016 - in compliance with 1.7.4 Machine Directive 2006/42/CE
G.B.C. Industrial Tools S.p.A.
Via Sandro Pertini 41/43 – 25046 Cazzago San Martino (Bs) – Italia – Tel. + 39 030 7451154 – Fax. + 39 030 73 56 629
We suggest to perform a service c/o G.B.C. Industrial Tools S.p.A. premises eve-
ry 400 hours working cycles.
•
Verify the general conditions of the machine;
•
Always use the lubricator when using pneumatic machines
•
Ensure the lubricator is mounted the nearest possible to the machine and
that the lubricant contained is supplied by G.B.C. In-dustrial Tools S.p.A. only.
•
Perform a compressed air periodical cleaning on the threaded part of the gui-
ding shaft and in the rear part of the machine.
•
Always ensure that the seats of the tools on the chuck are clean
•
Every 20 – 30 hours ensure the security valve has no air leaks
•
Ensure no air leaks are present on the air supply system nearby the connection
between the machine and the hose.
•
Introduce some drops of gasoline or similar oily solvent in the air intake nipple
of the pneumatic motor and start the machine in idle.
•
Always use well sharpened tools to obtain the maximum result.
G.B.C. Industrial Tools is at your disposal for any information you may re-quire
about the above mentioned procedures and for any general clarification you may
need.
