EC OUTPUT SIGNAL
P-3
The EC output signal can be changed between 0-10V or
PWM (Pulse Wave Modulation). Refer to your fan to find
the type of EC signal required, the default is 0-10V which
works on all G.A.S EC fans.
Press the selector dial to select the EC output signal, turn
the selector dial to scroll through 0-10V & PWM which
will show on the screen as ‘PULS’. Press the selector dial
again when you have the desired value to save.
INTAKE FAN SETTING
P-4
By default the intake fan is turned off at minimum
speed. This setting can be changed in the menu shown
below. ‘ON’ will keep the intake fan on at
minimum speed.
Press the selector dial to select the setting, turn the
selector dial to change between ‘ON’ and ‘OFF’.
Press the selector dial again when you have the
desired value to save.
P-5 RESET TO FACTORY SETTINGS
You can reset to factory settings in the sub menu. This can
be useful if you want to set up the controller for a new
environment.
Press the selector dial to select the setting, once the
‘rSt’ value is flashing press the selector dial down for 4
seconds, the reset will be complete.
UNITS & RESET TO FACTORY
SETTINGS
P-5
The temperature units can be changed from °C to °F .
Press the selector dial to select the setting, turn the selector
dial to change between ‘°C’ and ‘°F’. Press the selector
dial again when you have the desired value to save.