FZG Parts Tremolo Switch, Инструкция по эксплуатации

Страница: 9 / 11

ENGLISH
8
Installation
1. First remove the stop screw of the tremolo switch.
2. Now place the Tremolo Switch in the tremolo compartment so that the front
edge is flush with the edge of the tremolo routing.
Note: You can either position the Tremolo Switch in the center of the tremolo
compartment - this way you can install up to four springs - or offset it upwards
towards the bass strings if you prefer your tremolo setup with three springs
(one spring in the center).
3. Mark the front hole for the countersunk screw. It's best to use a center punch
for this so that the drill doesn't slip when you put it in place. To prevent paint
from chipping, you can mask the drill hole with tape beforehand.
4. Pre-drill the hole with a 2mm drill bit. Then screw the Tremolo Switch with
the countersunk screw so that it can still be turned easily.
5. Screw the stop screw (M4) back into the bolt and unscrew it until the screw
head is in full contact with the tremolo block. The
Tremolo Switch should be
aligned as perpendicular as possible to the tremolo block.
6. Pre-drill the rear hole as described in steps 3 and 4 and screw in the remaining
screw. The rear hole has no centering. This means that the alignment of the
Tremolo Switch can still be slightly corrected. Check the perpendicularity to
the tremolo block again!
7. Remove the stop screw once more and tighten the front countersunk screw.
Afterwards it can be screwed in again and the
Tremolo Switch can now be
fine-tuned. In the following two variants for the correct adjustment are
described below.