BlueTexGPS Mobitex Integration guide v.2.6
14
If BT-powersave is active BlueTexGPS will turn off the bluetooth module after some
minutes, the timeout is set in minutes and is used for power on and off to,
There are tree power on methods, on/off button is default and the unit power on and
off by pressing the on/off button at the front of BlueTexGPS. When the unit is
configured as motion it starts when motion is detected and power off when there is
no motion for some minutes. The Charge power mode work as in motion mode but it
is the charger that trigs power on and off. The timeout for motion and charge power is
the same as for bt-powersave.
When external I/O is enable the serial interface in the dsub9 will be turned off, to
activate it again press the on/off button about 2 sec.
The S/N field is only for printing, it will be printed when printing to help keep the
printed settings apart.
Sending the settings
To send the settings to the unit connected press the send button. The program will
automatically ask the unit for its settings and verify that it was set correct, if it was not
an error message will appear.
View a units settings
To view a units settings press the request button. The program will ask the unit for its
configurations and display them in the fields (this will overwrite the data in the fields).
If you just want to update the field for software version and the units manid press the
update button instead.
Clearing the fields
The clear button clear all the fields. It will not clear the settings in the connected unit.
The clear command is also called when you do a request or sending the data to the
unit.
The print function
The print button will print the settings on a printer of your choice.
Incoming data
In the incoming data field the raw data that the program receives over the serial port
will be shown. This is under normal conditions GPS data.
Disconnecting
To disconnect just press the close button.
