FyeTech X4 & X4 Pro, Инструкция по эксплуатации

Страница: 19 / 27

© Preisler & Partner | UAVshop.co.uk
i
nsTall
f
rame
C
enTre
p
laTe
You can now install the middle frame plate. Take eight M3 x 25mm pil-
lars and bolt them to the underside of the lower frame plate, securing
with thread lock. Before installation, place a small piece of tape on the
underside of the middle frame plate (marked ‛B’) covering the
centre hole (for explanation, see ‛Hover Hold’ in ‛Pre Flight
Checks and Tips’ Section below).
Take the middle frame plate with the letter ‛A’ facing upwards, position plate on top of the
assembly, carefully align the slots with the four arms and slide carefully into position. Hol-
ding the frame plates firmly together, bolt through to the eight frame support pillars. Make
sure all slots are correctly inserted before tightening. Don’t forget to pull the 4 servo leads
from the ESCs out through the middle plate for later connection to the flight controller.
After installing the ESCs and frame centre plate, you can proceed to install the flight con
-
troller as per instructions.
19