FY-TECH FY-8L, Руководство пользователя

Страница: 17 / 21

Connect wave form wire electrode
tip with welding gun .
F006+F010+020
e 、
3 、 Operation
Set correct time .
Remark :
1 、 Setting amperage too high or time too long can cause workpiece surface (vehicle body)damage .
Please weld other workpieces for practice before actual operations .
2 、 Setting correct amperage and time according to the workpiece thickness .
3 、 Continuing another operation is applicable after these procedures finished .If not ,please
shut off the main power supply and switch off the unit.
Wav e Form Wire Weldi ng
P a g e . 1 5
Set Mode switch
Connect negative outside wire
to a clean,paint-free location
on metal workpiece,as close to
welding area as possible.
Connect hook puller with pull hammer .
Hook wave form wire and slide the
hammer to pull out the dent .
Place a wave form wire
horizontally on the dent .
Approximately a 90°angle
to wave form wire . Put on
pressure andpress trigger .
( P o s i t i o n A i s r e c o m m e n d ) .
Set c orre ct power