FY-TECH FY-6G, Руководство пользователя

Страница: 15 / 23

Connect triangel washer
pull hammer with welding gun .
Slide the hammer to opposite
direction to pull the dent
F003+F020
c
、
Triangle Washer Welding
Set correct time.
Approximately a 90° angle to
the dent,put on pressure
and press trigger.
3 、 Operation
Remark :
1 、 Setting amperage too high or time too long can cause workpiece surface (vehicle body)damage .
Please weld other workpieces for practice before actual operations .
2 、 Setting correct amperage and time according to the workpiece thickness
3 . Triangle washer welding can replace washer welding . It can draw out the concavity directly
after welded .
4 、 Continuing another operation is applicable after these procedures finished .If not, please
shut off the main power supply and switch off the unit .
P a g e . 1 3
Set Mode switch
Connect negative outside wire
to a clean,paint-free location
on metal workpiece,as close to
welding area as possible.
( P o s i t i o n A i s r e c o m m e n d ) .
Set correct pow er