FXO H.323 Gateway User Manual
Document Ver.: 118a
Release Sep, 2004
73
-eod End of dial (0=Disable, 1=Enable).
-ring The ring time for ring detection.(Uint:ms)
-rba Ring before answer.(For 1 ~ 10)
-silence Detect silence voice. (0=Disable, 1=Enable)
-delay Delay too add DTMF.(Fpr 1~ 5 sec)
-connect Auto connect time.(0=Disable, for 1~ 10)
-fxotype FXO type.(0=Normal, 1=Force 2nd dial)
Example: sysconf -idtime 5
Example: sysconf -ring 500
Parameters Usage:
print out all current settings
-idtime
set the duration(in second) of two pressed digits in dial mode
as timed out. If after the duration user hasn’t pressed next
number, it will dial out all number pressed. (1-10 seconds)
-keypad
DTMF replay type. When value is “0”, Gateway will transfer
DTMF signal via In-Band type, “1” via H.245 UII Alphanumeric,
“2” via H.245 UII Signal Type, and “3” via Q.931 UserInfo, and
“4” via RFC2833 type. Users can adjust the value according
to various applications.
-prefixsw
switch on/off prefix function. If user enables prefix function,
once user dials out, gateway will automatically add prefix
number before number user dialed.
-prefixdisab set disable key (0,1,~9, *) to disable the prefix function in
this current call. For example, if user has set prefix as 100,
and wants to dial out 100123, user can only press 123, to
dial out 100123.However, if user wants to dial 123 without
prefix, user can press prefix disable key, for example “*”,
user can press “*”, then dial 123, gateway will dial out 123
without adding prefix.
-usrdefprefix define prefix number.
Note:
User can also define IP address here in P2P mode,
once user press “#”, Gateway will call out this IP address.
Note:
“prefixsw”, “prefixdisable”, “usrdefprefix” commands must work together.
