FXA XCLICK FXAJD6322, Инструкция по эксплуатации

Страница: 8 / 72

8
Check carefully to ensure that the machine is in good
condition and account for all the accessories listed in
this manual.
Also make sure that all the accessories are complete.
If any parts are found to be missing, the machine and
its accessories should be returned together in their
original packaging to the retailer.
Do not throw the packaging away, keep it safe
throughout the guarantee period, then recycle if
possible, otherwise dispose of it by the proper means.
Do not let children play with empty plastic bags due
to the risk of suffocation.
CHARGING THE BATTERY PACK
Warning! Only charge in compatible 18V chargers.
Use of other chargers may result in fire, damage or
serious personal injury.
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it until the green LED on
the front right hand side of the charger comes on.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (operation
followed by recharging) for them to become fully
charged.
First read the safety instructions then follow the
charging instructions.
Connect the charger transformer cable into the
charger base, Fig.2.
Plug the charger into a standard 230V~50Hz mains
socket outlet, the green LED on the front left hand
side of the charger will illuminate.
Do not allow the cable to become knotted or kinked.
Place the charger base onto the battery pack, Fig.3.
(Note the battery has raised ribs which allows it to fit
into the charger only one way). Time the charge for
3-5 hours only.
The red LED on the front right hand side of the
charger will illuminate to indicate charging is in
progress. A green LED will illuminate when the battery
is fully charged.
Unplug the charger when not in use and store it in a
suitable storage cabinet.
Avoid charging your battery in freezing conditions as
charging power will not be sufficient.
When charging more than one battery pack in
succession allow at least 30 minutes for the charger
to cool down before charging an additional battery.
Always remove the battery pack and store it safely
when the tool is not in use.
Caution: If at any point during the charging process
none of the LEDs are lit, remove the battery pack from
the charger to avoid damaging the product. DO NOT
insert another battery.
CHARGE STATUS
To display the amount of charge left in the battery,
press the charge level indicator button, Fig.4.
INSTALLING THE BATTERY PACK
Warning!
Battery tools are always in operating
condition. Always remove battery pack from your tool
when you are assembling parts, making adjustments,
cleaning, or when not in use. Removing battery pack
will prevent accidental starting that could cause
serious personal injury.
Slide the battery pack into the tool base. (Note the
battery has raised ribs which allows it to fit into the
tool only one way). Make sure the battery pack snaps
into place and that battery pack is secured in the tool
before beginning operation.
Improper installation of the battery pack can cause
damage to internal components.
REMOVING THE BATTERY PACK
Locate the battery release catch on the top of the
battery and press downwards. Whilst holding down
the battery release catch slide the battery pack away
from the tool.
VARIABLE SPEED CONTROL (FIG. 5)
Simply apply light pressure to the trigger to start the
drill on a slow speed. Increasing the pressure on the
switch will increase the speed of the drill.
Note: You might hear a high pitched noise from the
switch during use. Do not be concerned; this is a
normal part of the switch function.
Charge level indicator Amount of charge
remaining
0-10%
10-25%
25-50%
50-75%
75-100%