FXA FXAJD5803, Инструкция по эксплуатации

Страница: 9 / 52

9
UNPACKING
Caution!
This packaging contains sharp objects. Take
care when unpacking. Remove the machine, together
with the accessories supplied, from the packaging.
Check carefully to ensure that the machine is in good
condition and account for all the accessories listed in
this manual. Also make sure that all the accessories
are complete. If any parts are found to be missing, the
machine and its accessories should be returned
together in their original packaging to the retailer.
Do not throw the packaging away, keep it safe
throughout the guarantee period, then recycle if
possible, otherwise dispose of it by the proper means.
Do not let children play with empty plastic bags due to
the risk of suffocation.
CHARGING THE BATTERY PACK
Warning! Only charge in compatible 18V chargers. Use
of other chargers may result in fire, damage or serious
personal injury.
The battery pack for this tool has been shipped in a
low charge condition to prevent possible problems.
Therefore, you should charge it until the green LED on
the front right hand side of the charger comes on.
Note: Batteries will not reach full charge the first time
they are charged. Allow several cycles (operation
followed by recharging) for them to become fully
charged.
First read the safety instructions then follow the
charging instructions.
Plug the charger into a standard 230V~50Hz mains
socket outlet, the green LED on the front left hand side
of the charger will illuminate.
Do not allow the cable to become knotted or kinked.
Place the battery pack into the charger base.
(Note the battery has raised ribs which allows it to fit
into the charger only one way). Time the charge for 60
minutes only.
The red LED on the front right hand side of the charger
will illuminate to indicate charging is in progress. A
green LED will illuminate when the battery is fully
charged.
Unplug the charger when not in use and store it in a
suitable storage cabinet.
Avoid charging your battery in freezing conditions as
charging power will not be sufficient.
When charging more than one battery pack in
succession allow at least 30 minutes for the charger to
cool down before charging an additional battery.
Always remove the battery pack and store it safely
when the tool is not in use.
Caution: If at any point during the charging process
none of the LEDs are lit, remove the battery pack from
the charger to avoid damaging the product. DO NOT
insert another battery.
CHARGE STATUS
To display the amount of charge left in the battery,
press the charge level indicator button, Fig.2.
ASSEMBLY
Warning!
To prevent accidental starting that could
cause serious personal injury, always remove the
battery pack from the product when assembling parts.
ASSEMBLING THE BLOWER TUBES
The blower tube can be installed on the blower without
using any tools.
Slide the blower tube onto the blower housing until the
lock button clicks into place, Fig.3.
Insert the concentrator nozzle onto the blower tube
until the concentrator nozzle lock button clicks into
place, Fig.4. (Concentrator nozzle is used to increase
air flow in tight areas: flower beds. under decks, etc.).
INSTALLING THE BATTERY PACK
Warning!
Always remove battery pack from your tool
when you are assembling parts, making adjustments,
cleaning, carrying, transporting or when not in use.
Removing battery pack will prevent accidental starting
that could cause serious personal injury.
NOTE: To avoid serious personal injury, always remove
the battery pack and keep hands clear of the lock-out
button when carrying or transporting the tool.
Slide the battery pack into the blower base, Fig 5.
(Note the battery has raised ribs which allows it to fit
into the blower only one way).
Charge level indicator Amount of charge
remaining
0-10%
10-25%
25-50%
50-75%
75-100%