FWE Removable Back Heat Module or models operate on
120 volt or 220-240 volt, 60 Hz, 1 ph, A.C. (unless ordered
otherwise), and are equipped with a three prong grounding
cord plug for your protection against possible shock hazards.
Be sure to plug only into a properly grounded three prong wall
receptacle. If you have any questions with regard to adequate
wiring or grounding in your building, a qualified electrician should
be contacted before using your cabinet. The amperage of your
heat module is stamped on the name plate attached to the unit.
DO NOT, UNDER ANY CIRCUMSTANCES, CUT OR REMOVE
THE GROUNDING PRONG FROM THE CORD PLUG.
WARNING:
ONLY A QUALIFIED ELECTRICIAN SHOULD
ATTEMPT TO REPAIR OR REPLACE ELECTRICAL
COMPONENTS OR WIRING.
BE SURE THAT MODEL IS UNPLUGGED FROM ELECTRICAL
SOURCE BEFORE REMOVING CONTROL PANEL.
FWE PTS SERVER BACK HEAT BOX
SERIAL AND MODEL NUMBER
INSTALLATION AND CARE
UNPACKING
ELECTRICAL REQUIREMENTS AND GROUNDING
These numbers are found on the nameplate (serial tag) affixed
to the back of the unit. Please record them in this booklet, in the
space provided. When ordering parts and/or service, you will
need to provide this information. The voltage and amperage of
the unit are also stamped on the serial tag.
After uncrating your cabinet and heating unit, remove all tape
and padding which held all doors, shelves, racks, cord, etc., in
place during shipment.
4
