FuzzDog PHASE 90, Быстрый старт

Страница: 2 / 8

Important notes
If you’re using any of our footswitch daughterboards,
DOWNLOAD THE DAUGHTERBOARD DOCUMENT
•
Download and read the appropriate build document for the daughterboard
as well as this one BEFORE you start.
•
DO NOT solder the supplied Current Limiting Resistor (CLR) to the main
circuit board even if there is a place for it. This should be soldered to the
footswitch daughterboard.
POWER SUPPLY
Unless otherwise stated in this document this circuit is designed to be
powered with 9V DC.
COMPONENT SPECS
Unless otherwise stated in this document:
•
Resistors should be 0.25W. You can use those with higher ratings but
check the physical size of them.
•
Electrolytics caps should be at least 25V for 9V circuits, 35V for 18V
circuits. Again, check physical size if using higher ratings.
LAYOUT CONVENTIONS
Unless otherwise stated in this document, the following are used:
•
Electrolytic capacitors:
Long leg (anode) to square pad.
•
Diodes/LEDs:
Striped leg (cathode) to square pad. Short leg to square pad for LEDs.
•
ICs:
Square pad indicates pin 1.