Wiring shown overleaf will disconnect the battery when you remove the jack
plug from the input, and also when a DC plug is inserted.
Snap the little metal tag off the pots to mount them flush in the box.
You should use some kind of heat sink on the legs of the diodes when
soldering. They aren’t keen on heat. Any more than 3-4 seconds of iron
and they’re toast.
There are multiple pads for GND as well as pads for Jack-IN and Jack-
OUT. These are used when combined with a Direct-Connect Daughterboard.
If you aren’t using a daughterboard just ignore J-IN, JI, JO and J-OU, otherwise
please refer to the daughterboard document for more details.
The pads for the pots are spaced so
you can use vertical pots if you wish.
Why not try “Cheating Vericals” by
soldering snipped component legs to
the pots as shown left. You can just
wire them normally though.
1 2
3
PC
B
La
yo
ut
©
20
14
P
ed
al
P
ar
ts
L
td
.
