ASSEMBLING YOuR pRO X-3
Place the
T-Bar
over the fork tube
and push the
T-Bar
down until it
touches the top of the
Headset
.
Adjust the
Front Wheel
and the
Clamp
so that the
Front Wheel
is
perpendicular to the
T-Bar
.
Securely tighten all three bolts.
Check to be sure that the
T-Bar
is
securely attached to the fork tube.
3
1
2
3
FAILURE TO PROPERLY ASSEMBLE AND TIGHTEN ALL BOLTS AND COMPONENTS MAY CAUSE LOSS OF SCOOTER
CONTROL AND INCREASE RISK OF FALLING. MAKE CERTAIN THAT YOU FULLY UNDERSTAND ALL THE ASSEMBLY AND
MAINTENANCE INSTRUCTIONS OR IF NOT CONTACT A QUALIFIED SCOOTER SERVICE DEPARTMENT.
MAINTENANCE TIpS
It is the responsibility of the owner or guardian to periodically inspect the wheels, nuts, T-bar,
tightness of the T-bar and bearings for wear and tear, and check for proper tightness. Always make
sure to tighten all bolts and nuts before you ride.
Eventually wheels, self locking nuts and bearings wear and need replacement. The life of these
components depend on the kind of riding done. Lots of braking will wear out wheels and riding
in dirty or wet conditions will prematurely shorten bearing and fasteners life. Worn wheels and
bearings are considered normal wear-and-tear and are not covered by the Nextsport Limited
Warranty. Wheels other than genuine Fuzion wheels may not be compatible with your scooter.
Always use genuine Fuzion replacement parts.
CLEANING YOUR SCOOTER
Wipe with a damp cloth to remove dirt and dust. Do not use industrial cleaners or solvents as they
may damage the surfaces. Do not use alcohol, alcohol-based or ammonia-based cleaners as they
may damage or dissolve the plastic components or soften the decals or decal adhesives.
FUZION PRO X-3
owner’s manual
