Method of Usage
Method of Usage
VII. Installation Instructions for Armrests
1 Locate the connector plug and air pipe (two wires, two air pipes) corresponding to
.
the armrests from the rail bracket. Pass them from the rear end of the rail bracket
(Figure 1).
2. After passing the connector plug from the rear end of the rail bracket, correspond
to each butt connection plug and air pipe (butt connection as per the mark on the
physical butt connections) (Figure 2).
Figure 1
Figure 2
3 Pass the connector from the bottom of the steel rail bracket, and correspond to
.
the armrest connector and insert it to the position firmly. Similarly, insert the air
pipe connector to the position firmly (Figure 3).
4 After connecting with the corresponding connection wires, gently insert them into
.
the bottom of the steel rail bracket from the rear side of the middle of the steel
pipe of the steel rail bracket by hand, and take care to avoid the air pipe bending
(Figure 4).
5. Holding the front and rear ends of the armrest with both hands, insert the
positioning shaft at the rear end of the armrest into the positioning shaft card at
the lower end of the rail frame first and then gently push the armrest up, and
check whether or not the armrest positioning shaft is inserted firmly (Figure 5).
6. Pick up the armrest with both hands and then insert the front hook of the armrest
into the front square opening of the massage chair frame (Figure 6).
Figure 3
Figure 4
Figure 5
Figure 6
7. Then use 4 cross-recessed pan head tapping screws M6X16 combined with
Φ5
f
lat washer to lock the armrest whose front hook has been inserted into the front
square opening of the massage chair frame in the second step with the main
body tightly on the inner side of the front end of the armrest (Figure 7).
8.Unzip the upper arm cover, and lock the armrest with the configured flat gasket
and M6*25 screw.(Figure 8).
Figure 7
Figure 8
1
2
VIII
. Installation Instructions for Legrest
·
After connecting the wires and the air hose between the legrest and the massage
chair, remove the cable ties and insert the connecting part into the seat (Figure 1).
·
Place the round tubes on the left and right sides of the legrest onto the legrest
support (Figure 2)
37
36
