Translation of original operating instructions for petrol chainsaw FX-KSP series
37
Mount the chain cover again on the drive
unit (A). To do this:
Align the stud with the mounting holes of
the chain cover.
At the same time, align the carrier of the
chain brake in the chain cover with posi-
tive fit with the counterpiece on the front
hand guard. If necessary, move the hand
guard back and forth repeatedly until the fit
is positive.
Pull the guide rail forwards in the elon-
gated hole and, by doing so, tension the
saw chain.
Secure the chain guard hand-tight with
the 2 nuts (
2.
).
Use the chain tensioner adjusting screw (
1.
)
to tension the saw chain and align the guide
rail.
NOTE
Only tension the saw chain sufficiently to al-
low it to be pulled lightly by hand along the
length of the guide rail.
NOTE
A new saw chain stretches during operation.
Loose saw chains wear very quickly and can
slip off the guide rail.
Therefore, switch off after sawing the first few
times, check the chain tension and retension
as necessary.
Tighten the 2 nuts to a torque of
12-15 Nm (
2.
).
Push the saw chain by hand one full rota-
tion around the guide rail and in doing so
check that the chain is correctly tensioned.
Operation
Fuel and chain oil
CAUTION!
Never use a 4-stroke oil mixture for the fuel
and oil. This mixture would cause major en-
gine damage!
WARNING!
Danger of explosion! Observe the following:
Keep fire and naked flames away from
areas in which fuel is used and stored.
Do not smoke when handling fuel.
Mix and store fuel only in containers (B)
approved for this purpose.
Only replenish the fuel-oil mixture in the
open.
Wipe away leaks immediately with
a clean cloth.
Also wait for as long as necessary until
the flammable components have evapo-
rated.
