REAR LIGHT »R-20 EB«
GB
Technical facts and references
u
With 3 LEDs
u
Tested and approved in accordance with
the German Road Traffic Licensing Regula-
tions (StVZO)
u
The reflector surface of the taillight must
be oriented vertically to the road and at a
right angle to the longitudinal axis of the
road.
u
Nominal performance: 0,6 W
u
Input voltage: 6V (6-12V) DC AC
PLEASE NOTE
If an LED fails, the entire light unit must
be replaced!
Important:
The 6-12 V DC version is marked with the
symbol DC AC. It should be noted that the
use of the 6-12 V DC AC version is only
permitted for bicycles with electric assisted
pedalling (e-bikes) if, following a discharge-
based shut-down of the support drive, an
uninterrupted power supply to the lighting
system is ensured for at least two hours, or
if the drive motor can be used temporarily
as a generator in order to continue to supply
power to the lighting system.
The light is switched on/off using the bike
control unit with pedal assistance.
Connecting the rear-light:
Pull the + and – slide-appliance out of the housing (1), insert the designated cables in the
particular port and then push the slide-appliance back into the housing again (2).
Atachment of the rear-light:
u
Mounting hight: 250-1200 mm
u
Attach the rear light with the designated
screws,nuts and washers to the carrier of
the bicycle.
u
When attaching the tail light, make sure
that the screws are tightened so tightly
that the light can not.
Before every
journey, en-
sure that the
headlight is
not covered.
1
3
2
1 red Main-LED
vehicle`s longitu-
dinal axis
Screw:
M5 x 15
2 LED red
Input: DC AC
Powersupply
Power cable +
Power cable +
Power cable -
Power cable -
Slide
Slide
R-20 EB
DC AC 6V (6V-12V) 0,6W
R-20 EB
DC AC 6V (6V-12V) 0,6W
R-20 EB
DC AC 6V (6V-12V) 0,6W
