Operators and Technicians Manual
©
2002 – 2007 FutureLogic, Incorporated. All Rights Reserved.
MNL Page 6 of 52 12/07/2007
MNL-000003 REV.N
Performing a Self Test
Press the FEED button during power up or reset to run a self test. This self test prints a
configuration ticket if the test passes successfully. The test ticket (illustrated in Figure 2-4)
contains important information on how the unit is configured.
Figure 2-4
Sample Configuration Ticket
Clearing a Paper Jam
The printer is designed to operate reliably with minimal paper jamming. If you need to clear a
paper jam, follow the instructions below. After you clear a paper jam, perform these steps in
reverse to load paper.
When clearing a paper jam:
•
Ensure that all paper paths from the entry point at the back of the paper well, through the
printer, cutter, and the ticket module chute are clear of paper or obstructions.
•
Use the Lid Release Lever located on the top of the unit.
•
Do not allow a screwdriver or other probing object to come in contact with the printer. This
can cause permanent damage to the printer.
Model:
PSA-66-ST2
Firmware:
GRUSA4100 TKT-2.3
COMMUNICATION
Interface:
serial
Baud Rate:
19200
Data Bits:
8
Parity:
NONE
Handshaking:
XON/XOFF/HARDWARE
PRINT CONTROL
Darkness Control:
+00%
Black Bar Index:
Enabled
Print On Demand:
Disabled
Auto Sleep Timer:
Off
SYSTEM RESOURCES
FLASH -Used:
000000
-Free:
024064
LIBRARY INVENTORY
Templates:
0,1,2,3,4,5,6,7,8,9,A,B
Print Regions:
1,2,3,4,5,6,7,8,h,9,A,B
C,D,E,F,G,I,J,K,L,N,O,P,
Q,R,S,T,U,Z,X,a,b,c,d,e,
f,g,i,j,k,l,m,n,o,p,q
Graphics:
E,F,G,H,I,J,K,L,M,N,O,P
Fonts:
3,1,2,4,7,8,5
Model number
System
communications
setup
Print Control Parameters
Amount of memory
available for user-defined
font and graphics storage is
indicated by the “Free”
space.
Listing of stored
Templates, Print
Regions and Graphics
Resident ticket template
package version
Firmware version
List of fonts available
in the printer by TCL
page mode
