Future light LC-01, Руководство пользователя, Страница: 19 / 21

Please note, the starting address depends upon which controller is being used.
Only use a stereo shielded cable and 3-pin XLR-plugs and connectors in order to connect the controller with
the fixture or one fixture with another.
Occupation of the XLR-connection:
If you are using controllers with this occupation, you can connect the DMX-output of the controller directly
with the DMX-input of the first fixture in the DMX-chain. If you wish to connect DMX-controllers with other
XLR-outputs, you need to use adapter-cables.
Building a serial DMX-chain:
Connect the DMX-output of the first fixture in the DMX-chain with the DMX-input of the next fixture. Always
connect one output with the input of the next fixture until all fixtures are connected.
Caution: At the last fixture, the DMX-cable has to be terminated with a terminator. Solder a 120
Ω
resistor
between Signal (–) and Signal (+) into a 3-pin XLR-plug and plug it in the DMX-output of the last fixture.
Addressing
The Control Board allows you to assign the DMX fixture address, which is defined as the first channel from
which the LC-01 will respond to the controller.
For address setting, press the MODE button until the display shows "DMX MODE".
Controlling:
After having addressed the LC-01 DMX Controller, you may now start operating it via your controller.
51834100_V_1_0.DOC 19/21