Future light 51834022, Руководство пользователя, Страница: 17 / 20

17
•
EN
Notes
• Always connect one DMX output to the DMX input of the next unit until all units are connected, to form a DMX
chain. Connect a 120
Ω terminating plug to the DMX output of the last DMX unit in the chain
• If the cable length exceeds 300 m or the number of DMX devices is greater than 32, it is recommended to insert
a DMX level amplifier to ensure proper data transmission.
•
Alternatively, provide each DMX-controlled unit with its individual receiver to avoid cabling between the DMX
units.
Pin connection:
OPERATION
Setting up a point-to-point connection
1 Connect transmitter and receiver to the mains power grid and switch both devices on with the power switch.
Normally, the DMX LED lights at none of the devices. If it lights or flashes on one of the devices, press
FUNCTION on the corresponding device until the LED goes off.
2 Shortly press FUNCTION on the transmitter.
The DMX LED flashes quickly on both devices until the wireless connection is established. Once connected,
the LED flashes slowly.
The assignment of the receiver to the transmitter is kept memorized even after disconnecting the power
supply.
Setting up a point-to-multipoint connection
1 Connect the transmitter and all receivers to the mains, while all devices remain switched off.
2 Turn on the transmitter and the first receiver with the power switch.
Normally, the DMX LED lights at none of the devices. If it lights or flashes on one of the devices, press
FUNCTION on the corresponding device until the LED goes off.
3 Shortly press FUNCTION on the transmitter.
The DMX LED flashes quickly on both devices until the wireless connection is established. Once connected,
the LED flashes slowly.
4 Turn on the next receiver with the power switch.
5 Shortly press FUNCTION on the transmitter.
The DMX LED flashes quickly on all devices until the wireless connection is established. Once connected,
the LED flashes slowly.
The assignment of the receiver to the transmitter is kept memorized even after disconnecting the power
supply.
6 Repeat steps 4 and 5 on all receivers involved.
Disconnecting a transmission path
1 To disconnect a transmission path through the transmitter, press FUNCTION on the transmitter for about five
seconds.
The connection to all receivers is being interrupted. The DMX LED goes off on all receivers.
2 To disconnect a transmission path through the receiver, press FUNCTION on the receiver for about five
seconds.
The connection from the transmitter to this receiver is being interrupted. The DMX LED goes off on this
receiver.