Future Design MCT-CM, Руководство пользователя

Страница: 151 / 247

MCT-CM
151
entry fields will be disabled, but will display current connection information used by the MCT. In order to enter
a static address, press the button to turn it off.
To set the static network address, enter a valid
IP Address , Subnet Mask and Default Gateway . The DNS
Servers are not required, but typically the IP address of the network router is entered to provide one. Consult
your network administrator for the proper values. The IP address must not be a duplicate of any other address
on the network or the interface will not operate correctly. The entry fields except IPV4 addressing format only.
The MCT does not except IPV6 addressing.
NOTE: When DHCP is on and the MCT is disconnected from the network, the entry fields on the Ethernet
screen will continue to display connection information based on its last valid connection for diagnostic
purposes. The IP address on the main Communications screen (or shown in the notifications list)
always displays the current address used by the MCT. If the IP address on the Communications
screen displays the loop-
back address of “127.0.0.1” then no connection is present.
When DHCP is off, the IP address on the Communications screen will always display the user entered
static IP address regardless of connection status. It does not indicate whether a valid network
connection is present or not.
9.9 Barcode Scanner
The Barcode screen provides access to the settings for the optional barcode scanner. These include settings
to turn the barcode scanner on and off, applying a prefix to scanned data and a test window for verifying proper
operation.
Barcode scanner operation is enabled through the “Start the automatic program” and “Annotation” on/off
buttons. The selections are mutually exclusive, i.e., only one can be enabled at a time. When one option is
turned on, the other is automatically turned off.
When the
Start the automatic program option is turned on, if the scanned data matches the name of a
ramp/soak program stored in memory, the MCT will automatically load the program and prompt the user to start
it. If the user presses ‘Yes” to start the program it will be downloaded to the CM and will begin operation on the
first step.
When the
Annotation option is turned on, the scanned data will be written to the currently running data log file
as operator event.
The
Prefix field allows the user to enter up to 16 characters that will then be used as a prefix to the scanned
value when matching a ramp/soak program name or when it is inserted into the active data log file. This can
be used as a tag to describe what the scanned value represents, i.e., Lot or Batch number for example.