Page 2 of 5 // email [email protected] US tel +1(603) 742 9181 Europe tel +44 (0) 1438 833577
Features
1. Programmable maximum telescope height
2.
Programmable maximum left and right viewing angle
3.
Programmable intermediate viewing angle
Installation
1.
Apply power.
2.
Use the Future Automation IR remote for all the following steps
3. The buttons for all [STORE] sequences must be pressed sequentially with
no more than 2 seconds between each press
4.
Set the maximum telescope height
– the unrestricted maximum height of the UBL
telescope is. Most installations will require a lower custom height. To trim the
maximum height:
i.
Position the telescope at the required height using [IN], [OUT] and
[STOP] on the IR remote.
ii.
Press the [STORE], [OUT]. The new telescope height is now
configured.
iii.
If you make a mistake and need to set a higher viewing position,
press [STORE], [STOP], [OUT]. This will clear the programmed
height and revert to the default maximum extension
iv.
Test your new height using the [IN] and [OUT] buttons
5.
Set the maximum left and right rotations. The UBL can rotate to a maximum of
180 degrees left and right. Some installations may require you to limit this to a
shallower angle
i.
Position the swivel at the required maximum rotation using [<], [>]
and [STOP] on the IR remote.