· After setting on the Procross 8.0 DS, the TILT function will be prepares automati-
cally (TILT LED [c] flashes slowly). Approx. 60 seconds after the device is levelled
and in case there was no manipulation by the user during these 60 seconds, the
TILT fucntion will be active (TILT LED [c] flashed fast).
During the countdown and when the Tilt fucntion is active, the tilt indicator sym-
bol [F] is continiously visible on the screen of the remote control
· The laser is tilted
When there has been an impact on the laser device, it will go into tilt. An alarm
will sound. The TILT LED [c] will now light up red continuously and the laser
beams will be turned off. The Tilt indicator symbol [F] and the Levelling symbol
[G] on the screen of the remote control starts flashing.
You must now check the measurement again before continuing. You can re-acti-
vate the laserlines by pushing the Tilt button [3] on the device or on the remote
control (if the remote function is activated). The TILT LED [c] will turn off.
After checking the measurement, you can re-activate the tilt function bij pushing
the Tilt button [3]. The TILT LED [c] will start flashing slowly again. After approx.
60 seconds the Tiltfunction will be active again.
· Sensitivity of the Tilt function
In exceptional cases it is recommended to use a slightly less sensitive tilt func-
tion. You can lower the sensitivity of this tiltfunction by long press the receiver
button [7] on the laser device (not on the remote control). The LED indicators of
the Horizontal [a] and/of Vertical [f] lines (this depends on which lines are active)
will start flashing. The sensitivity of the tilt function is now lower.
Keep in mind that a lower sensitivity increases the chance of measuring errors.
To turn the sensitivity back to normal, long press the receiver button [7] again.
The LED indicators of the Horizontal [a] and/of Vertical [f] lines (this depends on
which lines are active) will no longer flash flash, but light up continiously.
SLOPE FUNCTION
The Futech Procross 8.0 DS has 3 different types of slope functions: Manual slope,
Electronic slope, Digital slope.
·
it is no longer Possible to (de-)activate laserlines using the device keyPad as
long as the sloPe function is activated. activate the desired laserlines before
activate the sloPe function or use the remote control to change the active
laserlines.
Manual slope
Activate the manual slope function by pressing the power button [1] of the device
for approx. 2 seconds OR by pressing the slope button [2] on the remote control.
The Level/Slope LED [d] of the device becomes red and the display of the remote
control shows the Slope indicator [J] and the Manual mode sign [I].
You can use the rotating legs of the Amphibase to gently position the device at
the desired angle. You can also physically position the unit at the desired slope by
using an inclined surface or by using a slope adapter (not included).
To turn off the manual slope, press the power button [1] for approx. 2 seconds OR
press the slope button [2] on the remote control again. The Level/Slope LED [d]
starts blinking green (levelling) and the Levelling symbol [G] flashes on the display
of the remote control untill the device is levelled again.
Electonic slope
To use the electronic slope op the Procross 8.0 DS, you have to activate the man-
ual slope function of the device by pressing the power button [1] of the device for
approx. 2 seconds OR by pressing the slope button [2] on the remote control.
The Level/Slope LED [d] of the device becomes red and the display of the remote
control shows the Slope indicator [J] and the Manual mode sign [I].
