1M23N12743
WARNING
Turn on the power in transmitter → receiver or-
der. In addition, always check the operation of
all the servos before use.
Do not insert or remove the servo connector
while the receiver power is ON.
■
Since the S.BUS2 servo switches the operation mode
automatically according to the type of signal (S.BUS
signal/PWM signal) from the receiver, if the connector
is inserted or removed while the power is ON, an S.BUS
connected servo will be erroneously recognized and
may stop.
Do not leave the servo in the locked state.
■
Leaving the servo in the locked state (state in which
enough force is applied that the servo cannot move)
may cause smoke, fire, and damage.
Never connect the battery in reverse.
■
Reverse connection may cause smoke, fire, and damage.
Do not expose the servo to dust and water.
■
The servo does not have a waterproof construction. If it
gets wet, the servo may not operate or the power supply
may short circuit.
When installing the servo, check PUSHROD LINK-
AGE to make sure there is no binding in order to
prevent excessive power consumption and de-
crease the life of the motor and battery.
CAUTION
Do not touch the servo case immediately after
servo operation.
■
You may be burned because the motor and circuits in-
side the servo become hot.
Do not turn the servo horn with unreasonable
force.
■
The servo may be damaged.
Do not disassemble or modify the servo.
■
The servo has a precision construction. Futaba Corp. will
not be responsible for any disassembly or modification
other than those specified by us.
Do not drop the servo or expose it to strong
shocks or vibrations.
■
It will damage with a shock.
Use the servo as an actuator in hobby applica-
tions.
■
Futaba will not be responsible if the servo is used in ap-
plications other than the above.
• Power supply
Use the battery as specification. Use a battery or a voltage
regulator with an ample margin as the power supply. The
specified performance cannot be displayed with a dry cell
battery.
Even if using a receiver with the BATTERY FAIL SAFE func-
tion, it may not operate correctly. Therefore, decide the
safe number of uses by paying careful attention to the re-
maining battery capacity.
• System use
For full performance, 2.4GHz system is recommended.
Use this servo by car receiver. This servo cannot be used by
air receiver.
• Programming function(P.G.)
This servo has Futaba S.BUS2 system. This servo can be
connected to a PC by using the CIU-2 USB Adapter sold
separately and its various operating characteristics can be
changed as a programmable servo by means of dedicated
software "S-Link". S-Link is downloadable from a Futaba
WEB site. Depending on a setup, a servo carries out vibra-
tion. If a servo continues carrying out vibration, it will break,
please restore a setup.
Car SV Servo Usage Precautions
قRUك
Futaba will not be responsible for damage,
etc. caused by the use of parts other than
Genuine Futaba parts.
FUTABA CORPORATION
1080 Yabutsuka, Chosei-mura, Chosei-gun, Chiba-ken, 299-4395, Japan
Phone: +81 475 32 6982, Facsimile: +81 475 32 6983
©FUTABA CORPORATION 2013, 8 (1)
