FUTABA CGY750, Инструкция по эксплуатации

Страница: 37 / 124

R
UDDER
G
YRO
B
ASIC
S
ETTING
37
(4) Limit setting [default: 100%, setting
range: 50~150%]
When the CGY750 is in the Sv.Limit param-
eter the gyro will no longer operate and the tail
servo will always center when the tail rotor stick
is released.
Always exit setup functions before attempt-
ing to fly the model. Before each flight
always ensure that the gyros are operating
and compensating in the correct direction.
The Servo Limit parameter within the CGY750
is used to set the mechanical limits for the tail
rotor servo. To obtain the best performance it
is recommended to set the limit in the CGY750
TO FOR BOTH DIRECTIONS AND THEN ADJUST
the servo arm length to set the mechanical
endpoints. After that has been completed use
the servo limit parameter to make small adjust-
ments that could not be made mechanically.
6ALUESBETWEENANDARECONSIDERED
optimal.
.AVIGATE TO THE ;25$'YRO="ASIC
´
Sv.Limit
menu and slowly move the rudder stick to the
left or to the right maximum extent and use the
data [+] or [-] key to increase or decrease the
maximum throw respectively. Ensure that the
pitch slider does not reach the maximum extent
and cause binding.
 WARNING
￸ When using the CGY750 for the first time,
or when making mechanical changes involving
throw, you must check and set the servo limits
again to prevent binding.