41
be turned on and off with the
keys.
Using the 8UA Timer Function
To ATV
function
To TH-CUT function
Timer's
minute setting
Data input keys
These keys are used to move
around in the TIMER menu
Timer Minutes Setting
Set the minute display with the
(+)/(-) keys.
Timer Seconds Setting
Press the right (>) key, then use the
(+)/(-) keys to set the seconds.
Count Up or Down Selection
Again press the right (>) key, then
select the type of timer with the
(+)/(-) keys.
Switch Direction Selection
Select the on and off switch
directions with the (+)/(-) keys.
UP = Switch's upper position
turns on the fnction.
DOWN = Switch's lower
position turns on the function.
CNTR = Switch's center
position (if any) turns on the
function
NULL = Switch not used
Timer Switch Selection
Select the desired switch
location with the (+)/(-) keys.
You may choose any of
switches A-H, throttle stick(STK-3),
or power switch (POWER SW).
When you change switches,
the chosen on/off directions are
reset to NULL. If this is the
case, be sure to choose the
directions you want.
Switch display
(SW-A-H and
STK3)
Switch direction display
(NULL, UP, CNTR, DOWN)
seconds
setting
If you want motion of the throttle stick to activate the timer (STK-3), you'll need to set the ON-OFF
stick position and direction for the stick to turn the timer on and off as follows:
1. First, position the throttle stick so that it's in the location where you want to have the timer switch on and off.
2. Next, press both of the (+)/(-) keys simultaneously to make the transmitter memorize the location.
3. Now you'll choose which side of the set point is on, and which side is off. If you want to turn on the timer at
the hight throttle stick position, press the (+) key. If you want to turn on the timer at the low throttle stick
position, press the (-) key. After you choose the direction, an up or down arrow is displayed at the top (high)
or bottom (low) side of "3" at the top right corner of the display, to confirm the switching direction you have
chosen. Move the throttle stick back and forth to confirm that the timer starts and stops as desired.
Timer Type display
(UP or DN)
